Troy-Bilt storm tracker 2690xp 用户手册

Refer to the Engine Operator’s Manual packed with your snow 
thrower for instructions on starting and stopping the engine.

With the throttle control in the Fast (rabbit) position, move 

1. 

the shift lever into one of the six forward (F) positions or 
two reverse (R) positions. Select a speed appropriate for 
the snow conditions and a pace you are comfortable with. 
Squeeze the drive control against the handle and the snow 

2. 

thrower will move. Release it and the drive motion will 
stop.

To engage the augers and start throwing snow, squeeze the 
auger control against the left handle. Release to stop the augers.

With the drive control engaged, squeeze the right steering 
trigger control to turn right. Squeeze the left steering trigger 
control to turn left. 

To activate the heated grips, move the switch found on the rear 
of the dash panel into the ON position. See Fig. 5-1.

It is recommended that you wear gloves 

when using the heated grip. If the heated grip 
becomes too hot, turn it off.

Move the track lock lever to the right, then forward or backward 
to one of the three positions. See Fig. 5-2.
NOTE: When positioning the track lock lever into one of the three 
operating locations, apply a downward force on the right handle 
with your left hand while you shift the track lock lever into the 
desired position with your right hand.