Ariens 911086 - lm21, 911087 - lm21s 用户手册
GB - 13
2. For engines with a primer, push primer
bulb 2 or 3 times for a cold engine.
NOTE: It is unnecessary to prime or choke a
warm engine.
warm engine.
3. With engine/blade control held against
the handlebar, grasp starter handle and
pull rope slowly until it pulls harder. This
is the compression stroke. Let rope
rewind slowly.
pull rope slowly until it pulls harder. This
is the compression stroke. Let rope
rewind slowly.
4. Pull rope with rapid continuous full arm
stroke to start engine. Allow rope to
rewind slowly.
rewind slowly.
IMPORTANT: DO NOT let starter handle snap
against bracket.
against bracket.
5. Repeat steps 4 and 5 until engine starts.
(If engine does not start, refer to
Troubleshooting.)
Troubleshooting.)
Shut Off
1. Release wheel drive control and allow
unit to stop completely (self-propelled
models).
models).
2. Release engine/blade control.
Mowing Tips
Cut grass when it is dry.
Keep mower blades sharp.
Do not set cutting height too low. For tall
grass, mow twice.
Do not mow too fast.
grass, mow twice.
Do not mow too fast.
Discharge clippings into areas already cut.
Vary cutting pattern with each mowing.
NOTE: To prevent dirt and grass from
collecting on mower pan, avoid operating over
bare ground with only patches of grass.
NOTE: To prevent dirt and grass from
collecting on mower pan, avoid operating over
bare ground with only patches of grass.
Mulching Tips
For best mulching performance, cut no more
than 1 inch (2.54 cm) of grass per cutting.
than 1 inch (2.54 cm) of grass per cutting.
Ariens Dealers will provide any service, parts
or adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine require service, contact an Ariens
dealer or an authorized engine manufacturer's
service center.
or adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine require service, contact an Ariens
dealer or an authorized engine manufacturer's
service center.
MAINTENANCE SCHEDULE
NOTE: Some working conditions (heavy
loads, high ambient temperatures, dusty
conditions, or airborne debris) may require
more frequent service.
See engine manual for further maintenance
and troubleshooting information.
loads, high ambient temperatures, dusty
conditions, or airborne debris) may require
more frequent service.
See engine manual for further maintenance
and troubleshooting information.
After first 5 Hours of operation
CHECK ENGINE/BLADE
CONTROL
CONTROL
The engine and blade must stop within 3
seconds after releasing the control. If the
engine and blade continue to run, adjust or
repair control immediately. See Service and
Adjustments.
seconds after releasing the control. If the
engine and blade continue to run, adjust or
repair control immediately. See Service and
Adjustments.
MAINTENANCE
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
and understand the entire Safety
section before proceeding.
MAINTENANCE SCHEDULE
Service Performed
Before
Each
Use
25
100
Check Engine/Blade
Control
Control
•
Check Wheel Drive
Control
Control
•
Check Grass Bag
•
Clean Unit
•
Check Engine Oil
•
Check Mower Blade
•
Check Drive Belt
•
Check Fasteners
•
Check Air Cleaner
•
Change Engine Oil
•
General Lubrication
•
Check Spark Plug
•
Check Engine
Cooling
Cooling
•
Check Muffler
•
*
*