Telex SS-1002 用户手册

Audiocom intercom stations, such as the US2002A, can transmit an inaudible signal to turn off the microphones in all remote 
intercom stations on an intercom channel. This is useful when a remote intercom station has been left unattended with the 
microphone on. The procedure to send a mic kill signal from a master station is a two-step process, so it is very unlikely 
microphones are ever turned off by accident. However, you may wish to disable the Mic Kill Receive feature at the intercom 
unit. You might do this, for example, if communications are of a very critical nature, where it is absolutely essential the 
microphone never be remotely deactivated. 

To enable the mic kill function, do the following:

Set DIP switch 1 to the open position. 

To disable the mic kill function, do the following:

Set DIP switch 1 to the closed position.

For Audiocom setup, do the following:

Verify Dip Switch 2 is in the OPEN position. 

Verify the Balanced/Unbalanced switch is in the Balanced position. 

For Clear-Com setup, do the following:

Set DIP switch 2 to the CLOSED position. 

Set the Balanced/Unbalanced switch to the Unbalanced position.

Incoming calls are always indicated by a red flashing call key. 

To set the incoming call beep in the headphones, do the following:

Set DIP switch 3 to the OPEN position (default). 
DIP switch 3 must also be in the OPEN position if you want to activate incoming call beep to the speaker using DIP 
switch 5.

If you are using a headset, telephone handset, or dynamic handheld microphone:

If the specifications indicate the microphone type is balanced, do the following:

Set DIP switch 4 in the open (default) position. 

If the specifications indicated an unbalanced microphone, do the following:

Set this switch to the closed position. 

If you are not sure, leave the switch in the open position for now. Try both positions during operations. Use the 

position that produces the best audio quality at other stations.