Tecumseh lh318sa-lh358sa (hmsk80-110) 用户手册

下载
页码 32
Page 24
4-Cycle • Snow King Engine
181-1275-14
IX. Storing Your Engine
A. Short-Term/Seasonal Storage
I.
Clean Engine
Before servicing the engine remove the carburetor cover 
and/or blower housing. Remove dirt and debris from the 
following areas: 
• Cooling Fins
• Air Intake Screen or Recoil Starter/
Flywheel Guard Areas
• Oil Fill Cap/Dipstick
• Fuel Fill Cap Areas
• Spark Plug Connection
• Levers 
• Linkage Area
• Guards
• Carburetor
• Head
Removing debris will insure adequate cooling, correct 
engine speed and reduce the risk of fire.
II. Fuel Storage
NEVER store engine with fuel in the 
fuel tank inside a building with 
potential sources of ignition such as hot water or space 
heaters, clothes dryers, electric motors, etc. Doing so may 
lead to an explosion resulting in death or serious injury. 
 NOTES
If engine fuel stored in the gas tank and/or an approved gas 
container is to be unused without gasoline stabilizer for 
more than 15-30 days, prepare it for short-term/seasonal 
storage. See "IV. Fuel Treatment" instructions. Afterward, 
continue reading instructions below.
If engine fuel is to be stored for more than one season, 
without gasoline stabilizer, it will gradually deteriorate. Also, 
if it is stored in the engine’s gas tank without gasoline 
stabilizer it is likely that your carburetor will have gum 
deposits, a clogged fuel system and WILL VOID YOUR 
WARRANTY
. Prepare the fuel for extended storage. See 
"B. Extended Storage" instructions. Afterward, continue 
reading instructions.
III. Fuel System
To avoid stale gas and carburetor problems, treat the fuel 
system in the following method below: 
 NOTES
TecumsehPower Company recommends using 
ULTRA-FRESH
™ Gasoline Stabilizer as an acceptable 
method of minimizing formation of fuel gum deposits during 
storage. This product is available from your Authorized 
TecumsehPower Servicing Dealer.
Always follow mix ratio found on stabilizer container. Failure 
to do so may result in equipment damage.
It is NOT necessary to empty stabilized gas from fuel tank. 
IV. Fuel Treatment
1.
Add fuel stabilizer according to manufacturer’s 
instructions.
2.
Run engine at least 10 minutes after adding stabilizer 
to allow it to reach carburetor.
NEVER store engine with fuel in fuel 
tank inside a building with potential 
sources of ignition such as hot water and space heaters, 
clothes dryers, electric motors, etc. Doing so may result in 
an explosion and result in death or serious injury.
 NOTE
Instead of using a fuel preservative/stabilizer, you can 
empty the fuel tank as described under "I. Draining Fuel" 
instructions. See "B. Extended Storage" instructions.
B. Extended Storage
I.
Draining Fuel
 NOTES
Clean debris from engine before emptying fuel from fuel 
tank. See "I. Clean Engine" instructions. Afterward, continue 
reading instructions below.
If you have prepared your fuel for short-term storage it is 
NOT necessary to empty fuel that contains stabilizer from 
your fuel tank. See "A. Short-Term/Seasonal Storage" 
instructions. Afterward, continue reading instructions below.
To avoid severe injury or death, 
DO NOT pour fuel from engine or 
siphon fuel by mouth.
1.
To prevent serious injury from fuel fires, empty fuel tank 
by running engine until it stops from lack of fuel. DO 
NOT attempt to pour fuel from engine.
2.
Run the engine while waiting until the remaining fuel is 
consumed. 
NEVER leave the engine unattended 
when it is running and NEVER run 
engine in enclosed areas to avoid death or serious injury.
3.
Begin servicing the cylinder bore. See "II. Oil Cylinder 
Bore" instructions on page 25.
WARNING
WARNING
WARNING
WARNING