Intermatic t21004r 用户手册

This control panel must be installed according to the National Electrical Code (including article 

680) or Canadian Electrical Code (including section 68) and local code requirements.  This installation is subject to the approval

by the local inspection authority. The main lugs and neutral main are suitable for No. 14 to 2 AWG COPPER conductors. Use

No. 14 to 6 AWG COPPER conductors for branch circuit wiring. Follow gauge selection table and corresponding terminal screw

tightening torque requirements below. Install interchangeable circuit breakers with an interrupting current rating of 10000 

symmetrical amperes, or higher. All circuit breakers in this control panel shall be of the same manufacturer and type. See list of

suitable types below. Follow manufacturers instructions for installing and testing of ground fault circuit breakers (GFCB) and

interrupters (GFCI). Install only LISTED receptacle(s) and/or wiring device(s) inside the enclosure. A LISTED wiring device may

be installed in the rectangular side knockout provided. When panel is outdoors, a LISTED rainproof cover must be installed over

the wiring device in the side knockouts. If this enclosure is used for direct conduit connection to a wet-niche or no niche 

luminaire, one of the connection kits listed below in Note 5 must be used. This control should not be connected to any 

equipment which would cause bodily injury or property damage should it be activated unexpectedly. After wiring, install front

panel over wiring compartment and close unused breaker openings with filler plates. 

1. Any Intermatic T100M or ET100CM series Time Switch, PF1000M 

Series freeze protection or RC2000M Series air switch mechanism

may be installed in the bracket provided or in the event an existing 

mechanism is replaced.

2. If this control panel requires bonding, attach a LISTED bonding

terminal of a suitable size using the mounting hole(s) provided on the 

bottom of the enclosure (156T11047A may be ordered).

3. When a back-fed breaker is used in this control panel, order 

22T904A to comply with NEC article 384-16 (g).

4. Wiring devices may be installed in this control panel (order 21T156A

(4) Standoffs for mounting).

5. The following kits are available to connect under water luminaires to this 

enclosure:

1/2” non-metallic - order 156PA13713A

3/4” non-metallic - order 156PA13714A

1” non-metallic - order 156PA13715A

1/2” metallic - order 156PA14336A

30 AMP. RESISTIVE, INDUCTIVE, TUNGSTEN OR 1000 VA PILOT DUTY -

120/208/240 VOLT A.C. 2 HP (24 FLA)-120 VOLT A.C., 

5 HP (28 FLA)-240 VOLT A.C.

(To order clock motor replacement, specify part no. WG--on motor cover)                   

Hold TRIPPERS against edge of CLOCK-DIAL,  pointing to time (AM or PM)

when ON and OFF operations are desired. Tighten tripper  screws firmly.

Pull CLOCK-DIAL outward. Turn in either direction

and align the exact time-of-day on the CLOCK-DIAL

(the time now, when switch is being put into opera-

tion) to the pointer.

-DO NOT MOVE POINTER-

• TO OPERATE SWITCH MANUALLY: Move MAN-

UAL-LEVER below left or right as indicated by

arrows. This will not affect the next operation.

• FOR MORE THAN ONE DAILY ON-OFF OPER-

ATION: Place additional tripper pairs on CLOCK-DIAL (order 156T1978A). 

• IN CASE OF POWER FAILURE: Reset CLOCK-DIAL to proper time of day.

See step 2 above.