HP Compaq KB-9965 311059-031 用户手册

 

  If no expansion board is installed in PCI-X slot 1, remove the expansion slot cover. 

6.  Remove the Torx T-15 screw holding the basket in place. The screw is located between 

slots 3 and 4 in the rear (1). 

7.  Pull up on the retaining pins securing the hot-plug expansion board basket to the system 

tray (2). 

8.  Press the plastic sleeve outward until the retaining tab snaps clear of the rear panel (3). 

9.  Lift the hot-plug expansion board basket from the system tray (4). 

 

Reverse steps 1 through 9 to replace the hot-plug expansion board basket. 

To remove the PCI backplane: 

1.  Prepare the server for a non-hot-plug procedure. Refer to “Preparing the Server for 

Non-Hot-Plug Procedures” in this chapter. 

2.  Remove the front bezel door (tower model only), and lay the server on its side with the 

access panel facing upward. Refer to “Removing the Front Bezel Door (Tower Model 
Only)” in this chapter. 

3.  Remove the access panel. Refer to “Removing the Access Panel” in this chapter. 

4.  Remove the memory board. Refer to “Removing the Memory Board” in this chapter.