Pride Mobility elite traveller series infinfb2039 用户手册

What if the battery condition meter dips way down and the motor surges or hesitates when I press the throttle
control lever?
 Fully charge the batteries. Pride recommends you charge the batteries for 8-14 hours.

DIAGNOSTIC BEEP CODES

   BEEP CODE

CONDITION

SOLUTION

   2

Battery voltage is too low to operate

Charge the batteries fully until charger and

the Travel Scooter.

any meters indicate completion.

   3

Battery voltage is too high to operate

Contact your authorized Pride Provider for

the Travel Scooter.

assistance.

   5

Solenoid brake trip. The manual freewheel

Remove the key, then push the manual

lever may be in the freewheel position.

freewheel lever to the drive position and
restart the Travel Scooter.

   6

Throttle trip. The throttle control lever

Release the throttle control lever completely,

may have been depressed while inserting

then reinsert the key.

the key.

   7

Throttle trip. Throttle potentiometer

Contact your authorized Pride Provider for

fault or speed potentiometer fault.

assistance.

   8

The motor is disconnected.

Contact your authorized Pride Provider for
assistance.

   9

Possible controller trip. You may be

Shut down your Travel Scooter for a

attempting to install the battery pack while

minimum of several minutes to allow the

the key is inserted or the motor controller

controller to cool. Or, try reinserting the key

may be in overheat protective mode.

into the key switch.