Philips 20hf5234 用户手册

 
 

 

- 6 - 

The Philips SmartLoader works in 2 modes – Wireless and Wired: 

 
Wireless mode ---- through infrared sensor (15/20HF5234) 

Switch the SmartLoader to “Wireless” mode by sliding the side-switch to the 

 icon on the SmartLoader 

device. Point the Wireless SmartLoader to the TV’s infrared receiver (optimal distance of 5-30cm) and proceed 

with the Installation procedure listed below. 

 
Wired mode ---- using the by-packed accessory cable(s) (20/26/32HF5335D) 

Switch the SmartLoader to “Wired” mode by sliding the side-switch to the 

 icon on the SmartLoader 

device. 
 

Examine the rear connectors of the TV set to determine if the 3-pin or 4-pin female connector wire (packed 
with the Wireless SmartLoader) should be used. Plug in the correct connector wire to the corresponding 

opening on the TV set (usually marked as SERV C), and then connect the RJ11 jack end of the accessory wire 

to the RJ11 socket on the SmartLoader.  
 

 
1.  Choosing a Master TV 

 
The Master TV is the TV set whose installation and configuration settings are to be copied into other TV’s (of 

the same type only). 

 
2.  Programming the SmartLoader with the settings from the Master TV 

 
Follow these steps to program the SmartLoader with the settings of the Master TV. 

 

a) Wireless 

method 

 Set the SmartLoader to “Wireless” mode using the side switch. 

 Turn on the TV, and while holding the SmartLoader, point it in the direction of the     

     TV. Press the “MENU” Key on the SmartLoader. 

b) Wired 

method 

 Connect the SmartLoader to the TV using the appropriate accessory cable.  
 Set the SmartLoader to “Wired” mode using the side switch. 

 Turn on the TV, and while holding the SmartLoader, point it in the direction of the    

     TV. Press the “MENU” Key on the SmartLoader. 

 

The Master TV will show the following menu: 

 

 

SMARTLOADER TO TV  > 
TV TO SMARTLOADER  > 

 

 
On the TV screen, highlight the menu option “TV TO SMARTLOADER” 

Press the right arrow key on the SmartLoader to start the programming process 

A number display (from 0~100) will be shown on screen, indicating the percentage of the programming 
progress from the TV to the SmartLoader. When the programming is completed, “##” will show “100” and the 

message “DONE” will appear. 
 

TV TO SMARTLOADER  ## (0-100) 

 

 

The SmartLoader is programmed and can be used to install and configure other TVs. 
 

Copying the settings of the Master TV to other TVs with the SmartLoader 

 
Follow these steps to install and configure the settings of a Philips TV with the SmartLoader.