Digitech df7 用户手册

1. Using the tip of a 1/4" guitar cable, push one

of the release pins in on either side of the

pedal, and remove the pedal from the pedal

chassis.

2. Remove the battery from the battery

compartment and disconnect the battery

cable.

3. Connect a new battery to the battery cable

and put it back in the battery compartment.

Make sure the battery cable does not

interfere with the spring or pedal switch

arm.

4. Place one hole of the pedal over its

corresponding pin.

5. Push the opposite pin in and lower the

other side of the pedal into place over the

depressed pin. Release the pin.When the

pedal is properly fastened, both release pins

are flush with the outer side of the pedal.