Manitowoc Ice Q 1800 用户手册

 
 

Ice machine produces shallow 

or incomplete cubes, or the ice  

Ice thickness probe is out of 

adjustment. 

Adjust the ice thickness probe.  

fill pattern on the evaporator is 

incomplete. 

Water trough level is to high or too low.  Check the water level probe for 

damage.  

 

Water inlet valve filter screen is dirty. 

Remove the water inlet valve and 

clean the filter screen.  

 

Water filtration is poor. 

Replace the filter. 

 

Hot incoming water. 

Connect the ice machine to a cold 

water supply 

 

Water inlet valve is not working. 

Remove the water inlet valve and 
clean it.  

 

Incorrect incoming water pressure. 

Water pressure must be 20-80 psi 
(137.9 - 551.5 kPA). 

 

Ice machine is not level. 

Level the ice machine. 

 

Low ice capacity. 

Water inlet valve filter screen is dirty. 

Remove the water inlet valve and 

clean the filter screen.  

 

Incoming water supply is shut off. 

Open the water service valve. 

 

Water inlet valve stuck open or leaking.  Remove the water inlet valve and 

clean it.  

 

 

 

In addition to the standard safety controls, such as 
the high pressure cutout, your Manitowoc ice 
machine features built-in safety limits which will 
stop the ice machine if conditions arise which could 
cause a major component failure. 

Before calling for service, re-start the ice machine 
using the following procedure: 

1.  Move the ICE/OFF/CLEAN switch to OFF and 

then back to ICE. 
A.  If the safety limit feature has stopped the ice 

machine, it will restart after a short delay. 
Proceed to step 2.  

B.  If the ice machine does not restart, see “Ice 

machine does not operate” on the previous 
page. 

2.  Allow the ice machine to run to determine if the 

condition is recurring. 
A.  If the ice machine stops again, the condition 

has recurred. Call for service.  

B.  If the ice machine continues to run, the 

condition has corrected itself. Allow the ice 
machine to continue running.