Royal Sovereign RSH-1050 用户手册

3.Place the machines on the plated place so that

4.Make certain that the machine is connecterd to an adequate power souce.

5.Do not use any other purposes other than
   Lamination.

1.Do not allow the machine to run with only one roll of film installed.  The 
   melted resin will adhere to one roller and ruin future laminations.

2.The width of film should be bigger than the material, and
   Width of upper side and lower side of film should be same in order not to allow
   melted resin to adhere to the rollers.

3.Be sure to adjust the film tension while in operation.
   If the tension is too tight, it could cause the film to stretch.

4.After work, you should clean the resin from
   the rollers before beginning the next operation.

5.Please check the lubricant after long operation 
   or you do not use for a long time.

6.Check the chain linking each gear is not loosened.
   The limit tension allowed is 3mm.

*Rollers do not operate

1. Power cord may not be plugged

1. Check the power cord

 after press RUN button

    in.

2. Check the switch is on

2. Power switch is at OFF mode.

3. Check the emergency switch

3. Emergency switch may be at

    is off

    ON mode.

4. Release STND-BY switch by

 

- 24 -

EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500