Maytag w10277179a 用户手册

■

To minimize possible shock hazard, the cord must be 
plugged into a mating, 3 prong, grounding-type outlet, 
grounded in accordance with local codes and ordinances. If a 
mating outlet is not available, it is the personal responsibility 
and obligation of the customer to have the properly grounded 
outlet installed by a qualified electrician.

■

If codes permit and a separate ground wire is used, it is 
recommended that a qualified electrician determine that the 
ground path is adequate.

■

Do not ground to a gas pipe.

■

Check with a qualified electrician if you are not sure the 
washer is properly grounded. 

■

Do not have a fuse in the neutral or ground circuit.

IMPORTANT: Position the washer so that the rear of the washer 
is within approximately 3 ft (900 mm) of its final location.

There are 4 shipping bolts in the rear panel of the washer that 
support the suspension system during transportation. These 
bolts also retain the power cord inside the washer until the bolts 
are removed. 

1. Keep the washer in the upright position while removing the 

shipping bolts.

2. Using a 1/2" wrench, loosen each of the bolts.

3. Once the bolt is loose, move it to the center of the hole and 

completely pull out the bolt, including the plastic spacer 
covering the bolt. 

4. Once all 4 bolts are removed, discard the bolts and spacers. 

Then push the power cord plug into the opening on the right 
side of the rear panel and pull the power cord through the 
opening on the left side of the rear panel and close holes with 
the attached cap. Do not pull plug end of power cord through 
the right side hole.

5. Close the bolt holes with the 4 transport bolt hole plugs.

NOTE: If the washer is to be transported at a later date, call your 
product distributor or installer. To avoid suspension and structural 
damage, your washer must be properly set up for relocation by a 
trained professional.

WARNING