Motorola 7.7.4 用户手册
171
SHELL Commands
SHELL Commands
Common Commands
arp
nnn.nnn.nnn.nnn
Sends an Address Resolution Protocol (ARP) request to match the nnn.nnn.nnn.nnn IP
address to an Ethernet hardware address.
address to an Ethernet hardware address.
clear [yes]
Clears the configuration settings in a Motorola Netopia® Gateway. If you do not use the
optional
optional
yes
qualifier, you are prompted to confirm the
clear
command.
clear_certificate
Removes an SSL cer tificate that has been installed.
clear_log
Erases the log information stored in flash if persistent logging is enabled.
configure
Puts the command line inter face into Configure mode, which lets you configure your Motor-
ola Netopia® Gateway with Config commands. Config commands are described star ting on
ola Netopia® Gateway with Config commands. Config commands are described star ting on
.
diagnose
Runs a diagnostic utility to conduct a series of internal checks and loopback tests to verify
network connectivity over each inter face on your Motorola Netopia® Gateway. The console
displays the results of each test as the diagnostic utility runs. If one test is dependent on
another, the diagnostic utility indents its entr y in the console window. For example, the
diagnostic utility indents the Check IP connect to Ethernet (LAN) entr y, since that test will
not run if the Check Ethernet LAN Connect test fails.
network connectivity over each inter face on your Motorola Netopia® Gateway. The console
displays the results of each test as the diagnostic utility runs. If one test is dependent on
another, the diagnostic utility indents its entr y in the console window. For example, the
diagnostic utility indents the Check IP connect to Ethernet (LAN) entr y, since that test will
not run if the Check Ethernet LAN Connect test fails.