Motorola 7.7.4 用户手册
263
CONFIG Commands
set security state-insp udp-timeout [ 30 - 65535 ]
Sets the stateful inspection UDP timeout inter val, in seconds.
set security state-insp dos-detect [ off | on ]
Enables or disables the stateful inspection Denial of Ser vice detection feature. If set to
on, the device will monitor packets for Denial of Service (DoS) attack. Offending packets
may be discarded if it is determined to be a DoS attack.
on, the device will monitor packets for Denial of Service (DoS) attack. Offending packets
may be discarded if it is determined to be a DoS attack.
set security state-insp xposed-addr exposed-address# "
n"
Allows you to add an entr y to the specified list, or, if the list does not exist, creates the list
for the stateful inspection feature.
for the stateful inspection feature.
xposed-addr settings only apply if NAT is off.
Example:
set security state-insp xposed-addr exposed-address# (?): 32
32 has been added to the xposed-addr list.
Sets the exposed list address number.
set security state-insp xposed-addr
exposed-address# "
exposed-address# "
n" start-ip ip_address
Sets the exposed list range star ting IP address, in dotted quad format.
set security state-insp xposed-addr
exposed-address# "
exposed-address# "
n" end-ip ip_address
Sets the exposed list range ending IP address, in dotted quad format.
32 exposed addresses can be created. The range for exposed address numbers are from
1 through 32.
1 through 32.
set security state-insp xposed-addr