Motorola 82543 用户手册

Installation and Removal

Gigabit Ethernet/82543 PMC Installation and Use

1-15

Continue to gently push until the prealignment guide pegs engage
with the backplane connector (Stage 2) and the injector levers make
contact with the chassis rails. DO NOT FORCE THE BOARD
INTO THE BACKPLANE SLOT.

4. Use the injector levers to seat the module in the slot by closing the

levers until they latch into the locked position (Stage 3). If the levers
do not completely latch, remove the module from the chassis and
visually inspect the slot to ensure there are no bent pins.

Note:

Install the PMC and host board assembly in its proper card slot.

Ensure it is seated properly in the backplane connectors. Do not damage
or bend connector pins.

5. When the module you are installing is completely latched, secure it

by tightening the captive screws at both ends of the faceplate.

6. Replace the chassis or system cover(s) and connect the system to the

AC or DC power source. Turn the equipment power on.

Connecting the Ethernet Cable to the PMC Module

Refer to

Table 3-7 on page 3-10

for Ethernet connector pin assignments

and to