Motorola RDU4100 用户手册

English

After cloning is completed, the Source radio will 

sound either a ‘pass’ tone (cloning was 
successful) or a ‘fail’ tone (cloning process has 
failed). The ‘pass’ tone sounds like a good key 
‘chirp’ whereas the ‘fail’ tone sounds similar to a 
‘bonk’ tone. If the Source radio is a display 
model, it will either show ‘Pass’ or ‘Fail’ on the 
display (a tone will be heard within 5 seconds).

Once you have completed the cloning process, 

turn the radios OFF and ON to exit ‘clone’ 
mode. 

The radio will emit an audible ‘bonk’ indicating 
that the cloning process has failed. In the event 
that cloning fails, try performing each of the 
following before trying to start the cloning 
process again:

Ensure that the batteries on both radios are fully 

charged.

Check the cloning cable connection on both 

SUCs.

Ensure that the battery is engaged properly on 

to the radio.

Ensure that there is no debris in the charging 

tray or on the radio contacts.

Ensure that the Source radio is in cloning mode.

Ensure that the Target radio is turned ON.

Ensure that radios are both from the same type 

(same frequency band, same front panel 
(display/non display), same region and same 
transmission power).

This cloning cable is designed to operate 
only with compatible Motorola RLN6175 
(Standard) and RLN6304 (Rapid) Single 
Unit Chargers.

When ordering Cloning Cable please refer to P/
N RLN6303. For details about accessories 
refer to Accessories section.