ICOM IC-F7000 用户手册
57
7
CONNECTION AND INSTALLATION
■
Antenna
Most stations operate with a whip or long wire (insu-
lated backstay) antenna. However, these antennas
cannot be connected directly to the transceiver since
their impedance may not be matched with the trans-
ceiver antenna connector.
lated backstay) antenna. However, these antennas
cannot be connected directly to the transceiver since
their impedance may not be matched with the trans-
ceiver antenna connector.
R
WARNING: HIGH VOLTAGE!
NEVER
touch the antenna element/wire while tun-
ing or transmitting.
With a 50 Ω matched antenna all HF bands cannot be
used. The following antenna matcher or antenna tuner
may be helpful for antenna installation.
used. The following antenna matcher or antenna tuner
may be helpful for antenna installation.
D
D
MN-100/MN-100L
ANTENNA MATCHERS
Antenna wire
MN-100/MN-100L
D
D
AT-130/AT-130E
AUTOMATIC ANTENNA TUNER
[E]:
[13.6]:
[START]:
[KEY]:
to antenna element
Control cable (Not supplied from Icom)
Assemble the connector using
the supplied connector kit.
See page 61 for pin assignment.
the supplied connector kit.
See page 61 for pin assignment.
D
D
Non-Icom tuner
Some non-Icom tuners may be used with the IC-
F7000. Please consult your dealer if you wish to con-
nect one.
F7000. Please consult your dealer if you wish to con-
nect one.
D
D
AT-140
AUTOMATIC ANTENNA TUNER
See page 55.