Chevrolet avalanche 2002 用户手册

3. Return to HomeLink in your vehicle and firmly 

press and release the programmed HomeLink button
three times.

The rolling

-

code garage door opener should now

recognize HomeLink. You may either use HomeLink 
or the hand

-

held transmitter to open the garage door.

If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1

-

800

-

355

-

3515, 

or on the internet at www.homelink.com.

Canadian Owners: During programming, the 
hand

-

held transmitter may automatically stop

transmitting after two seconds. In this case, you should
press and hold the HomeLink button (see Steps 2 and 3
under “Programming the HomeLink Transmitter”) while
you press and re

-

press (cycle) your hand

-

held transmitter

every two seconds until HomeLink is trained.

Press and hold the appropriate button on HomeLink for
at least half of a second. The indicator light will come
on while the signal is being transmitted.

To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Release both buttons.

To reset HomeLink to default settings, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Continue to hold both
buttons until the HomeLink indicator light turns off and
then release both buttons.

Accessories for the HomeLink Transmitter are available
from the manufacturer of the unit. If you would like
additional information, please contact the manufacturer
of HomeLink at 1

-

800

-

355

-

3515, or on the internet 

at www.homelink.com.