Chevrolet 2010 corvette convertible 用户手册
To program up to three devices:
1. Press START or put the vehicle in accessory
mode. See Ignition Positions on page 3‑23 for
additional information.
additional information.
Programming can only occur when the vehicle is
running or in accessory mode.
running or in accessory mode.
2. From inside the vehicle, press the two outside
buttons at the same time for one to two seconds,
and immediately release them.
and immediately release them.
3. Locate in the garage, the garage door opener
receiver (motor-head unit). Locate the “Learn”
or “Smart” button. It can usually be found where
the hanging antenna wire is attached to the
motor-head unit and may be a colored button.
Press this button. After pressing this button,
complete the following steps in less than
30 seconds.
or “Smart” button. It can usually be found where
the hanging antenna wire is attached to the
motor-head unit and may be a colored button.
Press this button. After pressing this button,
complete the following steps in less than
30 seconds.
3-44