Garmin 240 用户手册

4

Included in the 010-10251-00 transducer kit you should have:

•  Worm Gear Clamp

•  Cable Ties

•  Transducer

1. Loosen the Worm Gear Clamp until end of the band is clear of the worm 

gear.

2. Slide the clamp band through the slots on the transducer.

3. Place the free end of the clamp band into the worm gear and tighten 

until the band is through the worm gear.

4. Place the clamp and transducer over the body of the trolling motor. 

Finish tightening the clamp to secure the transducer to the trolling 
motor.

5. Secure the transducer cable to the trolling motor shaft using the sup-

plied cable ties.

If you are experiencing interference while the trolling motor is operating, try 
installing the transducer cable at right angles to the trolling motor power 
cables.

190-00155-10 Rev A.indd

08/16/00, 2:46 PM

4