Husqvarna FS 413 用户手册

. Using screws, washers and nuts installed in the Front 
Pointer (A), install onto tube frame of Water Tank Support 
(N).  Adjust locking nuts to allow Pointer (A) to pivot freely.

. Route pointer rope to avoid hot surfaces. Two loops in 
rope allow attachment to Rear Handle (JJ).

Note: “Single Pointer” (A) shown.  Some regions have 
“Dual Pointer” as standard equipment.  For all regions, 
Dual Pointer is available as an accessory.  See “accesso-
ries” section of this document, or spare parts list for more 
information.

Blade Guard Latch Plate 
(F) Must Be Installed 
before operation.  Failure 
to Install before operating 
machine could create a 
Hazardous situation!

Always keep all guards 
in place when operating 
machine!

Pull outward on Blade Depth Control Handle (EE) and 
rotate 90 degrees until is snaps in position shown.

. Reinstall three () M8 screws in Blade Guard Latch 
Plate (F) as shown in the diagram at the right.  Use the 
mm Wrench (U) (supplied) to securely tighten the four 
() M8 bolts that hold the Blade Guard Latch Plate (F) in 
position.

. Using mm Wrench (U) provided, remove two () M8 
screws located in front of and below Blade Guard Latch 
Plate (F), and the M8 screw in Blade Guard Front (D) [as 
indicated by arrows].  Lossen, but do not remove, remain-
ing screw Blade Guard Latch Plate (F).  Rotate Blade 
Guard Latch Plate (F), and Blade Guard Front (D) down-
ward.