Husqvarna FS 413 用户手册

Use: This machine is used only for wet or dry sawing of 
old and new concrete and asphalt.

 

 

Before operating machine, read and under-
stand this entire operation manual & engine 
operation manual supplied with engine. 

Be familiar with machine before operation!

DO NOT use carbide, wood saw, or circular saw 
blades on this machine, else injury or death could oc-
cur.

Blade Guard (C) is factory installed on right hand side of 
machine, but can be relocated to left side.  This may allow 
cutting closer to obstacles, if approaching them from the 
opposite direction is not possible.

. Use mm Wrench (U) to remove Blade Guard Rear 
Bolt (E) from Blade Guard (C).

. Push back collar to separate Water Hose Disconnect 
(G).  Male half remains with Blade Guard (C).  Female 
half remains with Water Tank (P) or Water Control Valve 
(KK).

. Lift Blade Guard (C) upward, and off of Blade Guard 
Mounting Spade (Y).

. Use mm Wrench (U) to remove four () screws that 
attach Blade Guard Latch Plate (F).  Re-attach the Blade 
Guard Latch Plate (F) to the left hand side of Blade Guard 
(C).

. Remove and relocate Shaft Guard (W) from left hand 
side of machine to right hand side.

. Lower Blade Guard (C) onto Blade Guard Mounting 
Spade (Y) on left hand side of machine.

. Re-Install Rear Bolt (E) in Blade Guard (C).

8. Re-Attach Water Hose Disconnect (G) from Blade 
Guard (C) to Water Tank (P) or Water Valve (KK). Take 

care that relocated hose will not contact muffler.
9. Relocate and realign Front Pointer (A) so Guide Wheel 
(B) is on left side of machine.

DO NOT use for dry cutting in European Union (EU) 
regions.  Machine is not equipped with a dust port.

Tools: Use machine only with the following tools (H): Wa-
ter Cooled Diamond Blades.  Reinforced Abrasive Blades 
or Dry Cutting  Diamond blades should NOT be used with-
in European Union (EU) regions because this machine, as 
supplied, does not include a dust collector port.

Diameter:  00 mm (”) – 00 mm (0”).

Bore: .mm (.00”).