Harbor Freight Tools 66187 用户手册

SKU 66187 

Page 3

6. 

Insert Arm (6) into Frame (1) and secure with 

Jam Bolt (D), as shown above.
Attach Ladder Stop (7) to Frame (1) using 

7. 

Carriage Bolt (M), Washer (N), and Nylon 

Insert Nut (P).
Install Strap (8) through the bracket on the 

8. 

Frame (1).
Slide the assembled Frame (1) into the Front 

9. 

Base (4).

1. 

Slide Rear Mounting Bracket (3) over Rear 

Base (5) as shown above.  Temporarily se-

cure in place with Jam Bolt (D).
Place the Base/Bracket assembly as shown 

2. 

below at the passenger side of the vehicle 

near the tailgate.  Loosen the Jam Bolt and 

allow the Base to slide down so the foot rests 

flat on the truck bed.
Mark the bedrail at center of the holes, 4 

3. 

holes in the side and 1 hole on the truck bed.  

Any one of the holes in the Base can be 

used for the truck bed hole.  Set the assem-

bly aside.
Drill for and install 5 Blind Fasteners (H) in 

4. 

the locations marked in the previous step.

5. 

Attach the assembly to the Blind Fasteners 

as shown above using Bolts (E), Washers 

(F), and Spring Washers (G) - as shown 

above.