Garmin gpsmap 2006, 2010 用户手册

63

Alarm Clock— The alarm clock has sounded.

Alarm Voltage Too High— Specifi ed voltage is too high, set to a lower value.

Alarm Voltage Too Low— Specifi ed voltage is too low, set to a higher value.

Anchor Drag Alarm— You have drifted out of the specifi ed distance range.

Approaching Waypoint— You are a specifi ed alarm distance from a destination waypoint.

Arrival At Waypoint— You have arrived at the destination waypoint.

Battery Alarm—Specifi ed amount of input voltage has been detected.

Can’t Unlock Maps— Data on data card is not unlocked for the unit. Contact your dealer or GARMIN.

Database Error— Tried to use an invalid or unavailable database point.

Deep Water Alarm —Specifi ed deep water alarm depth has been detected below the transducer.

GPS Antenna Failure, Antenna Needs Repair— GPS receiver problem. Contact your dealer or GARMIN.

GPS Antenna Has Lost Its Stored Settings—  GPS receiver problem. Contact your dealer or GARMIN.

Lost Position From GPS Antenna— The unit has lost satellite signals. Check antenna connections or try 
moving to a location with a clear view of the sky.

No DGPS Position— No differential correction data is available or not enough data is available to compute 
a DGPS position.

Off Course Alarm— You have exceeded the specifi ed off-course distance.

Proximity Alarm— You have entered the alarm radius for the proximity waypoint indicated.

Proximity Alarm Memory is Full— You have used all ten proximity waypoints.

Proximity Overlaps Another Proximity Waypoint—The alarm radius specifi ed overlaps the area speci-
fi ed for another proximity waypoint. Adjust distance.

Route Already Exists: <route name>— You have entered a route name that already exists in memory. 
Modify route name or delete the previous route name.

The GPSMAP 2006/2010 uses an on-screen pop-up message system to alert you to unit operating 

characteristics. Press the ENTER key to acknowledge and return to the page you were viewing.