Hitachi DZ-BD10HA 用户手册

„ Detaching the DC power cord/battery pack from 

the camcorder

„ Efficient use of the battery

• The battery will slightly discharge even if it is detached from the camcorder.
• If the battery is left attached to the camcorder, it will consume a slight amount of 

power. Therefore, it is recommended that you charge the battery a day before 

using the camcorder.

It is recommended that you fully charge the battery every six months, attach it to 

the camcorder, turn it on and fully deplete the battery charge, then remove the 

battery and store it in a cool place again.

The battery life varies greatly depending on the ambient environment and how often 

the camcorder is used. If the usable time of the camcorder with a fully charged 

battery is noticeably short, the battery should be replaced. Purchase a new one.

To save power, do not leave the camcorder in recording pause mode for too long.
Even during recording pause, battery power is consumed at about the same level as 

during recording.

By turning the power save function On, the camcorder will automatically turn off 

if left idle for approximately five minutes in recording pause mode. For power save 

function, see “About the LCD setup and initial setup” (p.42).

Notes

• The battery pack will not be charged while the DC power cord is connected to the 

AC adapter/charger even if the battery pack is attached to the AC adapter/charger.

• The AC adapter/charger can be used around the world. An AC plug adapter is 

required in some foreign countries. If you need one, purchase it from your local 
electronics distributor.

Always turn the power off before 
disconnecting the power supply.
While pressing and holding BATT, slide 
the DC connector or battery pack 
upward, then remove it.
• Be careful not to drop the battery pack 

while detaching it.