Mitsubishi Electronics colorview xd480u 用户手册

EN - 20

This projector adjusts the format of the video signal 
supplied from the computer. However, sometimes im-
ages are not projected correctly owing to the type of 
the computer used. When the image from the computer 
isn

't projected correctly, press the AUTO POSITION 

button. (See page 15.) If the image isn

't projected cor-

rectly yet, adjust the image from the computer using the 
menu.  

To move the image horizontally :
Adjust HORIZ. POSITION in the SIGNAL menu.  Press 
the 

 button to move the image to the left.  Press the  

button to move the image to the right.

To move the image vertically : 
Adjust VERT. POSITION in the SIGNAL menu.  Press 
the 

 button to move the image upward.  Press the  

button to move the image downward.

When the image fl ickers or the image is out of focus :
Adjust FINE SYNC. in the SIGNAL menu.

When the top part of the image fl ags :
Change the setting of HOLD in the SIGNAL menu. Se-
lect ON  , press the ENTER button, and adjust BEGIN 
or END to minimize the fl agging.

When wide strips appear : 
Adjust CLAMP POSITION or CLAMP WIDTH in the SIG-
NAL - USER menu.

When the motion doesn't run smoothly : 
Adjust VERT. SYNC. in the SIGNAL - USER menu.  Se-
lect AUTO for normal use. 

When noise appears on the right or left half of the 
image :
Adjust SHUTTER (LS) or SHUTTER (RS) in the SIGNAL 
- USER menu.

When noise appears on the top or bottom part of the 
image : 
Adjust SHUTTER (U) or SHUTTER (L) in the SIGNAL - 
USER menu.

Important:
Do not change any of the settings in the SIGNAL-USER 
menu for normal use.

1.  Select HORIZ. POSITION in the SIGNAL menu.

2. Press the 

 or  button to adjust the horizontal start 

position (or the left side of the image).

3.  Select TRACKING in the SIGNAL menu.

4. Press the 

 or  button to adjust the horizontal end 

position (or the right edge of the image).

5.  Repeat steps 1 to 4 for optimum adjustment results. 

6.  Select VERT. POSITION in the SIGNAL menu.

7. Press the 

 or  button to adjust the vertical start 

position (or the upper edge of the image).