OKI postscript 3tm 70049601 用户手册

Installation Instructions

PostScript 3 emulation Kit Part Number: 70049601

Oki Data Americas, Inc., Mt. Laurel, NJ 08054
http://www.okidata.com

1. Unpack the cards and remove any 

2. Turn off the printer, and remove 

3. Loosen the access panel screw.

 

4. Remove the access panel and locate 

the PostScript connector (1). 

5. Install the PostScript card:

a. Hold the card (make sure PS is 

on the label) so that the notch 
(2) is on the bottom right 
corner. 

b. Position the card into the 

connector.

c. Press down on the card until it 

snaps into place and the gold 
contacts are fully inserted in 
the connector.

6. Install the memory chip:

Insert the card with the notch 

towards the front of the printer. 
Press down on the card until it 
snaps into place and the gold 
contacts are fully inserted in the 
connector. 

7. Check to make sure that both 

cards are fully inserted and 
installed correctly. 

8. Replace the access panel:

a. Align the panel tabs at bottom.

b. Swing the panel up and in place.

c. Tighten the screw.

Print a Menu Map:

a. Press the Menu button one or 

more times until INFO.MENU 
appears on the display.

b. Press SELECT twice. The 

MenuMap prints.

c. PSE Program version and Total 

Memory Size 32 MB appears 
in the header, and PRINT PSE 
FONT in the Information 
Menu. If not, check to be sure 
that the cards are installed 
correctly.

58369502

(Continued on back)

Your printer is factory set to AUTO 
EMULATION (AUTO appears on 
the printer display). In this setting 
the printer will sample data and 
automatically switch between 
PostScript emulation and the other 
emulations. If the printer is not set to 
AUTO EMULATION, see the 
User’s Guide for instructions to set 
it in the printer Menu.