Husqvarna 80792 用户手册

10

NOTE: Operating with trimmer line of
uneven length will cause excessive
vibration. Always make sure the line is
wound evenly and trimmed to equal
lengths from the eyelets.

INSTALLATION INSTRUCTIONS

99909-007
Fits T230 and C230

99909-008
Fits T27, C27, T270, C270, T260,
C260, BP35

Note: This trimmer head can operate
either as a manual feed or a bump
feed.

99909-007
99909-008
Shipped with 21 feet of .080 line.
Maximum fill–

50 feet of .080
40 feet of .095
36 feet of .105

Turn the lower knob at the bottom of
the trimmer head clockwise to disas-
semble the halves.

Remove the spool from the housing.

Cut two equal lengths of trimmer line,
no longer than 25 feet each. Place an
end from each piece of line into the
holes in the center of the spool.

Wind the line clockwise onto the spool
following the direction of the arrows
stamped into the spool.

Clean the spool, housing and eyelets.
Inspect for wear and damage.
Replace damaged components.

Inspect the arbor bolt and replace it if
damaged. Reattach the eyelets if they
were removed or replaced. Never
operate a trimmer head without
eyelets!