Husqvarna 80792 用户手册

5

*2 required

1 Adapter Bolt

2  Outer Housing

To advance line:  With the engine off, loosen the bottom knob a few turns in
the direction of rotation. Grasp the trimmer head in both hands. Rotate the
bottom of the spool clockwise and pull the line through the eyelets. Re-tighten
the knob before operating the trimmer.

Use your finger to separate the line
into two sections. Doing so will assist
in a smooth line feed when the head
is reassembled.

Holding the spool and wound line
in one hand, place the lines 180
degrees apart.

Hold the spool over the housing and
feed one line end into an eyelet. As
you place the spool in the head, feed
the other line into the opposite eyelet.
Make sure one line does not slide
under the spool.

Tip: Sometimes it’s easier to remove
one eyelet to install the second piece
of line. Slide the eyelet over the line
two to three inches, then push the
eyelet in place as the spool is re-
placed in the housing.

Reinstall the spring and knob. Tighten
securely.

A properly wound and reassembled
head should have four or five inches
of line extending from each eyelet and
the overlap should be one to two
inches. Trim as needed to final length.

Item

Part No.

1

72036-15210

2

72005-92740

3*

72005-92630

4

72005-92720

5

72005-92660

6

72005-92770

Item

Part No.

1

72005-92710

2

72005-92740

3*

72005-92630

4

72005-92720

5

72005-92660

6

72005-92770

Item

Part No.

1

72017-92710

2

72005-92740

3*

72005-92630

4

72005-92720

5

72005-92660

6

72005-92770

3  Inner Spool

4  Eyelets

5  Spring

6  Button/Knob

1" to 2"