Hitachi c28w40tn 用户手册

Press the cursor down button to select

SURROUND SETUP.

The seating position control accommodates the position of the speakers with regard to your

seating position, and so further creates an atmosphere where improved sound qualities are obtained

from your TV. 

• If you are seated near the front speakers, 

adjust the seating position to FRONT.

• If you are seated between the front and 

rear speakers, adjust the seating position to MID.

• If you are seated at a position close to the rear speakers, adjust the seating position to REAR. 

Press and hold the MENU button for 5

seconds. The INSTALL option in the 

MAIN MENU appears.

Press the cursor down button to select

INSTALL.

Once highlighted, accept selection.

1

2

3

4

Use the cursor keys to move the

selection bar over the channel 

required to be adjusted. The effect of

these adjustments can be seen in the

accompanying on-screen display.

5

At Hitachi we appreciate the fact that not all living areas are the same, therefore the surround

setup menu allows the user to balance the sound by adjusting the volume level to each channel, thus

accommodating various room layouts. Please note that the surround setup menu is only available in

Dolby Pro Logic and Dolby Pro Logic Theatre modes and so the TV will automatically default to Dolby

Pro Logic when selected. NOTE: When the surround setup menu begins, the TV's sound is replaced by

a noise signal. This is easier to balance than normal TV sound, and will cycle between the centre, left,

right and surround channels - the centre channel cannot be adjusted unless an external amplifier for

the centre channel is connected  and is adjusted from PHANTOM to WIDE or NORMAL modes in the

'Speaker Setup' menu.

When the TV automatically cycles through the various sound channels, we suggest that you listen to

the TV sound for a few moments before adjusting any of the channels. By doing this you may be able

to determine which channels need adjusting. Once you have adjusted the selected level, leave the TV

to cycle through the Surround Setup menu a few times more, this will then allow you to  determine

whether you have applied the correct amount of volume level to the selected sound channel.