honda-power-equipment hrt216s3da 用户手册
Unpacking & Handlebar Setup
Remove all the protective cardboard from the mower, including the
piece around the handlebar.
piece around the handlebar.
Loosen the two knobs on the lower
section of the handlebar enough
so you can raise the handlebar
into the mowing position. Once the
handlebar is in place, tighten the
knobs securely.
section of the handlebar enough
so you can raise the handlebar
into the mowing position. Once the
handlebar is in place, tighten the
knobs securely.
Install Starter Rope
Disconnect the spark plug cap. Pull
the flywheel brake lever back, then
pull the starter grip toward the
starter rope loop. Release the
lever, then press the rope into the
loop. Connect the spark plug cap.
the flywheel brake lever back, then
pull the starter grip toward the
starter rope loop. Release the
lever, then press the rope into the
loop. Connect the spark plug cap.
Assemble Grass Bag
(HRT models only)
(HRT models only)
Slide the grass bag frame into the
grass bag, then install the clips as
shown. Lift the rear door and
install the grass bag.
grass bag, then install the clips as
shown. Lift the rear door and
install the grass bag.
ASSEMBLY
LOCKING KNOB (2)
LOOP
48