ONKYO dr-s501 用户手册

下载
页码 84
43
Using the Listening Modes—Continued
T-D (Theater-Dimensional) Listening Angle 
Setting
With this setting, you can specify the angle of the front 
left and right speakers relative to the listening position.
Processing for the Theater-Dimensional listening mode 
is based on this setting. Ideally, the front left and right 
speakers should be equidistant from the listening posi-
tion and at an angle close to one of the three available 
settings.
Note:
Only when the T-D listening mode is selected, this set-
ting is available.
Listening Mode and Receiver Settings
Depending on the listening mode, the setup menu settings may be enabled/disabled as shown below.
✔: available
*1 During playback a DVD-Audio or SACD, this setting is fixed at 100 Hz.
*2 During playback a DVD-Audio or SACD, this setting is fixed at Small.
1
Remote controller
HOLD
Press and hold the [SETUP] but-
ton for 3 seconds.
When selecting the input other than 
DVD, just press the [SETUP] button.
“Balance” appears on the display.
20/30/40°
Front left speaker
Front right speaker
2
Use the Up and Down [
]/[
buttons to select “Angle”, and 
use the Left and Right [
]/ [
buttons to select: “Narrow”, 
“Middle”, or “Wide”.
Narrow: Select if the listening angle 
is 20 degrees.
Middle: Select if the listening angle 
is 30 degrees (default).
Wide: Select if the listening angle 
is 40 degrees.
3
When you’ve finished, press the 
[SETUP] button again.
The setup menu closes.
Listening Mode
Settings
Page #
Pure Audio
Direct
Stereo
T-D
Speaker Output Balance
56
Subwoofer Level
32
Correcting Sound and Picture 
Sync
56
Crossover Frequency
57
*1
Enabling/Disabling the Subwoofer
56
Front Speakers Size
56
*2