Husqvarna 115 247227 R1 用户手册

14

follow the mower operation instructions in the mower 
operator’s manual.
When utilizing the grass catcher on a lawn where 
grass and leaf bagging equipment has not been 
used, thatch and debris that has accumulated for 
long periods of time will be picked up. The amount 
collected and the total time of operation may be 
greater than experienced with regular use of the grass 
catcher.

Always run throttle at full speed when bagging.

•

Select a speed low enough to give good mower 

•

cutting performance, good quality cut and good 
bagging performance.

If grass is extremely tall, it should be mowed 

•

twice. The first time relatively high, the second 
time to desired height.
Use left hand side of mower for trimming.

•

Plastic trash bags (3.0 mil, 30 gallon) can be 

•

inserted inside grass catcher containers for ease 
of debris disposal. To remove the plastic trash 
bags when full:

 

a.  Disengage blades, shift into neutral, engage 

the parking brake and stop the engine.

 

b.  Unlatch and raise cover.

 

c.  Remove one container at a time by grasping 

container handles and pulling toward the rear, 
off of the tube rails.

 

d.  With the container resting on the ground, 

close and secure the top of the plastic lawn 
bag.

 

e.  Tip the container on its side and slide the 

filled bag from the container.

 

f.  Install a new plastic lawn bag with the edges 

of the bag draped over upper lip of the 
container.

 

g.  Repeat for other containers.

 

h.  Reinstall containers making sure containers 

overlap left at center supports.

 

i.  Close cover and secure latches over center 

support tubes.

Avoid cutting wet grass or mowing in the morning 

•

while the dew is still heavy. Grass clippings 
collected under these conditions tend to be sticky 
and adhere to the walls of the flow path causing 
clogging.

If the grass catcher fails to pick up cut grass 

•

or leaves, it is an indication that clogging has 
occurred in the system or that the grass catcher 
containers are full.

 

a.  Disengage blades, place motion control 

levers in neutral position.

 

-  Unlatch and raise cover.

 

-  Slide out containers and dispose of 

clippings.

 

-  Replace containers, close cover, and latch.

 

b.  Unlatch chutes and check for clogging.

 

-  Remove all debris in chute.

 

-  Reassemble and latch chutes.

OPERATION