Husqvarna 115 247227 R1 用户手册

9

ASSEMBLY

Install the bagger mount tube to the rear guard 

1. 

with 

5

/

16

-18 x 3¼ bolts and flange nuts from kit. 

NOTE: Depending on model, rear guard hole may 
need to be drilled out to 

5

/

16

" if kit hardware is too 

large.
Install kit support straps on the outside of the 

2. 

mount tube as shown in the illustration. Using 
a 

5

/

16

-18 x 1¼ bolt, attach the front side of the 

strap to the fender support. Do not add flange 
nut at this time. Place the reinforcement plate to 
the outside of the fender support. Secure with 
additional 1¼ bolt and fasten both bolts with 
flange nuts. Repeat steps on opposite side.

Tighten all hardware. 

3. 

Remove rear engine guard (if installed) by removing 
the six bolts that attach the guard to the frame.

Place hitch on the rear of the mower.

1. 

Install two of the previously removed bolts through 

3. 

rear of the hitch weldment.
Secure the sides of the hitch to the frame with 

4. 

5

/

16

-18 x ¾ 

bolts and washers from the new 

hardware, (two per each side).