Husqvarna 413 用户手册

Refer to the engine operating manual for proper engine 
operation.

FUEL: Unleaded gasoline is recommended.  See engine 
operation manual for more information.

OIL: Check that engine oil level is correct using the 
Engine Oil Dipstick (Z).  When checking the engine oil 
level, the Engine Oil Dipstick (Z) should not be screw into 
the port.  Because the engine often operates at an angle, 
check oil level with engine horizontal. Check frequently to 
ensure that oil level never falls below lower mark on dip-
stick. 0W0 oil is recommended.  See engine operation 
manual for more information.

Front Pointer (A) must be checked for alignment with 
blade. Lay a straight edge along Inner Flange (I).  Align 
Front Pointer (A) to straight edge.  If required, adjust Front 
Pointer (A) by loosening nuts that hold Guide Wheel (B) 
in place. Align Guide Wheel (B) to straight edge and re-
tighten nuts.

Check that water tubing in the Blade Guard (C) is open 
and that each side of blade has an adequate supply of 
water.
Test the water supply for pressure and quantity (flow) 
before starting the saw.
Saw only as deep as the job specifications require.  Saw-
ing deeper than required will add excessive wear the 
blade and machine.

Cut in increments of 0mm ( inches) deep until cutting 

depth specification is reached.  This is known as “step 
cutting”.

Saw only in a straight line.  Mark cutting line clearly so  

saw operator can follow line without difficulty.  Saw should 
NOT be twisted from side to side to force blade back on 
line.

 

          

          gram): Parking brake must be dis-engaged  

 

          to operate machine.

. Pull lever (OO) toward center of machine.

. Rotate lever (OO) downward 80 degrees and release 
to lock in position.

If engine is equipped with a low oil shutdown system, 
engine will not start if oil level is low.  Also, engine may 
stop if maximum angle of operation is exceeded.  See 
engine operation manual.