Hitachi travelstar hds723020bla642 用户手册
7K200 SATA OEM Specification
54/173
12.5.1
Power Mode
Sleep Mode
The lowest power consumption when the device is powered on occurs in Sleep Mode.
When in sleep mode, the device requires a reset to be activated.
When in sleep mode, the device requires a reset to be activated.
Standby Mode
The device interface is capable of accepting commands, but as the media may not
immediately accessible, there is a delay while waiting for the spindle to reach
operating speed.
immediately accessible, there is a delay while waiting for the spindle to reach
operating speed.
Idle Mode
Refer to the section of Adaptive Battery Life Extender Feature.
Active Mode
The device is in execution of a command or accessing the disk media with read
look-ahead function or write cache function.
look-ahead function or write cache function.
12.5.2
Power Management Commands
The Check Power Mode command allows a host to determine if a device is currently in, going to or
leaving standby mode.
The Idle and Idle Immediate commands move a device to idle mode immediately from the active or
standby modes. The idle command also sets the standby timer count and starts the standby timer.
The sleep command moves a device to sleep mode. The device’s interface becomes inactive at the
The Idle and Idle Immediate commands move a device to idle mode immediately from the active or
standby modes. The idle command also sets the standby timer count and starts the standby timer.
The sleep command moves a device to sleep mode. The device’s interface becomes inactive at the
completion of the sleep command. A reset is required to move a device out of sleep mode. When a
device exits sleep mode it will enter standby mode.
The Standby and Standby Immediate commands move a device to standby mode immediately from
device exits sleep mode it will enter standby mode.
The Standby and Standby Immediate commands move a device to standby mode immediately from
the active or idle modes. The standby command also sets the standby timer count.
12.5.3
Standby/Sleep command completion timing
1. Confirm the completion of writing cached data in the buffer to media
2. Unload heads on the ramp
3. Set DRDY bit and DSC bit in Status Register
4. Activate the spindle break to stop the spindle motor
5. Wait until spindle motor is stopped
6. Perform post process
2. Unload heads on the ramp
3. Set DRDY bit and DSC bit in Status Register
4. Activate the spindle break to stop the spindle motor
5. Wait until spindle motor is stopped
6. Perform post process
12.5.4
Status
In the active, idle and standby modes, the device shall have RDY bit of the status register set. If BSY
bit is not set, device shall be ready to accept any command.
In sleep mode, the device’s interface is not active. A host shall not attempt to read the device’s status
or issue commands to the device.
12.5.5
Interface Capability for Power Modes
Each power mode affects the physical interface as defined in the following table:
Mode
BSY
RDY
Interface active
Media
Active
x
x
Yes Active
Idle
0 1 Yes
Active
Standby
0
1
Yes Inactive
Sleep
x x No
Inactive
Table 34 Power conditions
Ready(RDY) is not a power condition. A device may post ready at the interface even though the
media may not be accessible.