Hitachi travelstar hds723020bla642 用户手册
7K200 SATA OEM Specification
64/173
Set Max Set Password
Set Max Lock
Set Max Freeze Lock
Set Max Unlock
Set Max Lock
Set Max Freeze Lock
Set Max Unlock
12.10.1
Example for operation (In LBA mode)
Assumptions :
For better understanding, the following example uses actual values for LBA, size, etc. Since it is just
an example, these values could be different.
Device characteristics
For better understanding, the following example uses actual values for LBA, size, etc. Since it is just
an example, these values could be different.
Device characteristics
Capacity (native)
:
536,870,912 byte (536MB)
Max LBA (native)
:
1,048,575 (0FFFFFh)
Required size for protected area
:
8,388,608 byte
Required blocks for protected area
:
16,384 (004000h)
Customer usable device size
:
528,482,304 byte (528MB)
Customer usable sector count
:
1,032,192 (0FC000h)
LBA range for protected area
: 0FC000h to 0FFFFFh
Shipping HDDs from HDD manufacturer
When the HDDs are shipped from HDD manufacturer, the device has been tested to have a
capacity of 536MB,flagging the media defects not to be visible by system.
capacity of 536MB,flagging the media defects not to be visible by system.
1. Preparing HDDs at system manufacturer
Special utility software is required to define the size of protected area and store the data into it.
The sequence is :
Issue Read Native Max Address command to get the real device max of LBA/CYL. Returned value shows
that native device Max LBA is 0FFFFFh regardless to the current setting.
that native device Max LBA is 0FFFFFh regardless to the current setting.
Make entire device be accessible including the protected area by setting device Max LBA as 0FFFFFh via
Set Max Address command. The option could be either nonvolatile or volatile.
Set Max Address command. The option could be either nonvolatile or volatile.
Test the sectors for protected area (LBA >= 0FC000h) if required.
Write information data such as BIOS code within the protected area.
Change maximum LBA using Set Max Address command to 0FBFFFh with nonvolatile option.
From this point, the protected area cannot be accessed until next Set Max Address command is issued.
Any BIOSes, device drivers, or application software access the HDD as if that is the 528MB device
because the device acts exactly same as real 528MB device does.
Any BIOSes, device drivers, or application software access the HDD as if that is the 528MB device
because the device acts exactly same as real 528MB device does.
2. Conventional usage without system software support
Since the HDD works as 528MB device, there is no special care to use this device for normal use.
3. Advanced usage using protected area
The data in the protected area is accessed by following.
Issue Read Native Max Address command to get the real device max LBA/CYL. Returned value
shows that native device Max LBA is 0FFFFFh regardless of the current setting.
shows that native device Max LBA is 0FFFFFh regardless of the current setting.
Make entire device be accessible including the protected area by setting device Max LBA as
0FFFFFh via Set Max Address command with volatile option. By using this option, unexpected
power removal or reset will not make the protected area remained accessible.
0FFFFFh via Set Max Address command with volatile option. By using this option, unexpected
power removal or reset will not make the protected area remained accessible.
Read information data from protected area.
Issue POR to inhibit any access to the protected area.