Outback Power Systems GFX1424E 用户手册

22

 

900-0111-01-00 Rev A 

          

 

 

RTS cable (RJ11, 

4-conductor, 

telephone) 

MATE cable (RJ45, 

8-conductor, CAT5 

non-crossover)

MATE/HUB port

RTS port

The AC Wiring Compartment Board has ports for 
both the Remote Temperature Sensor (RTS) and 
the system display.  (The system display port is 
labeled MATE/HUB.)   

If a HUB is in use, it occupies the inverter’s 
MATE/HUB port.  

See the Operator’s 
Manual for more 
information on 
the RTS.   

MATE 

port 

Additional 

Ports 

The INVERTER ON/OFF jumper bridges two pins.  This jumper (JP1) 
parallels the two INVERTER ON/OFF terminals on the Control 
Wiring Terminal Block.  If either set of connections is closed, the 
inverter is ON.  (Because the jumper is factory-installed, the inverter 
usually remains ON unless given a command by the system display.)  

 

Removing the jumper will turn the 
inverter OFF.  To remove the jumper, 
use long-nose pliers or a similar tool. 

When a HUB occupies the inverter’s MATE/HUB port, the system 
display connects directly to the HUB.  

Inverters plug into ports 1 and above.  Charge controllers and 
other devices plug into additional ports after the last inverter is 
connected.  See Stacking on page 27 for information on 
connecting inverters.  See the HUB manual for other devices. 

 

Once the plastic INVERTER ON/OFF 
jumper has been removed, the INVERTER 
ON/OFF terminals on the Control Wiring 
Terminal Block can be used to wire a 
manual on/off switch.