Royal Sovereign RSC-1650C 用户手册
1. Put cold roll film on upper bar.(Set the same as methord of the HOT film for protect paper of lower
part)
2. Pull COLD film, and fix it so that backside protecting paper can be wound on take-up mandrel
clockwise. (Revolve core to make protectingpaper tight a little bit.)
3. Set pressure lever at the proper position following to your lamination condition.
4. After pressing the RUN/STOP button choose and set proper speed by using the SPEED
button or .
part)
2. Pull COLD film, and fix it so that backside protecting paper can be wound on take-up mandrel
clockwise. (Revolve core to make protectingpaper tight a little bit.)
3. Set pressure lever at the proper position following to your lamination condition.
4. After pressing the RUN/STOP button choose and set proper speed by using the SPEED
button or .
5. Turn on the take up device and set the proper film tension by pressing the RUN/STOP button.
Lower tension would make better operation.
Lower tension would make better operation.
10.
Set pressure lever at the Hard board/15mm mode.
11
. Turn off the power switch.
1. Set up the protection paper. Otherwise, glue form the film will be stuck on the face of roller
and it can be seriously damaged.
2. Turn the switch RUN/STOP and “Take up motor” at the same time.
and it can be seriously damaged.
2. Turn the switch RUN/STOP and “Take up motor” at the same time.
*** Reference ***
LAMINATING STEPS