Runco reflection vx-1000ci 用户手册

13

Remote Control Description

Illuminates when a button is pressed, indicating that an IR signal is being transmitted.

Toggles the power on and off. For a discrete on or off command, you can use the direct
access buttons (see 'J'). Note: When the main AC power switch is first turned ON, the
PFP Controller will go through an initiation cycle for approximately 15 seconds. The
PFP Controller cannot be turned on or operated until the initialization is complete. 

When no menus are present on-screen, the UP button will toggle you through aspect
ratios in the following order:
VirtualWide          Letterbox          Standard (4:3)          Anamorphic
When the menu is on-screen, the UP button will move the cursor up within the menu.
When an adjustment item has been selected (i.e. brightness), the UP button will
increase the value of that function.

When no menus are present on-screen, the LEFT button will toggle you through the six
different sources in the following order:

When no menus are present on-screen, the DOWN button will toggle you through
aspect ratios in the following order:
Anamorphic         Standard (4:3)

When the menu is on-screen, the DOWN button will move the cursor down  within the
menu. When an adjustment item has been selected (i.e. brightness), the DOWN button
will decrease the value of that function.

These buttons will allow you to directly access an aspect
ratio, source, or turn the unit on or off without having to
go through any menus. These buttons are:

1: Selects COMPOSITE video
2: Selects S-VIDEO
3: Selects COMPONENT video
4: Selects COMPONENT HD

M

PWR

A

B

C

D

E

J

F

G

H

I

1

2

3

4

5

6

7

8

9

I

N

P

U

T

0

N
P

U

T

I

OFF

ON

5: Selects RGB HD
6: Enables or disables the Installation Menu 
(see page 21)
7: Selects the ANAMORPHIC aspect ratio
8: Selects the STANDARD (4:3) aspect ratio
9: Selects the LETTERBOX aspect ratio
0: Turns the PFP Controller ON.
OFF: Also known as the button left of '0', this turns the
PFP Controller OFF.

When no menus are present on-screen, the RIGHT button will toggle you through the six different sources in the 
following order:

Pressing the MENU button will bring up the main menu. If no action is taken within approximately 10 seconds, the menu
will time-out (disappear). Also, if you are in an adjustment mode or function, pressing MENU will bring the menu back one
level.

When an item is highlighted on a menu, pressing ENTER will select that item.

If the remote control loses its 'memory' as a result of weak or dead batteries, it must be re-programmed for the
Controller's code set. To reprogram the remote to the default IR Code Set, press the PROGRAM button followed 
by 0,1,3. If you have set the Controller for a different Code Set (see pg. 22), enter that number instead of 0,1,3. 
Note: Pressing Enter after typing in the code is not necessary.