dixon-marking-tools ztl 312 用户手册

 

 

 

 

IMPORTANT - READ OPERATOR'S MANUAL BEFORE OPERATING OR MAKING ADJUSTMENTS

 

SEAT ADJUSTMENT

 

1. Pull or lift body retention latch (P/N 3934) 

from transaxle backing plate,  raise   and push 
body and seat assembly forward.

 

2. Loosen four seat ad jus tee/it knobs (P/N 1849) 

and slide seat forward or backward to desired 
position.

 

3. Re-tighten seat adjustment knobs (P/N 1849).  DO 

NOT operate Bower without seat adjustment knobs 
properly tightened.

 

4. Close upper body and push r e t e n t i o n

 

latch (P/N 3934) over transaxle backing plate.

 

REMOVING THE BODY 

 

1. The 312 has a (2) piece polyethelene body. The upper body can be folded forward 

to expose the transaxle.  In some cases, it nay be necessary to remove the 
upper body to service the transaxle.

 

2. To relieve upper body, remove two bolts (P/N 3080) from the  front of upper 

body hinge located on the brake shaft (P/N 9283). Disconnect seat 

switch 

(P/N 4761) at plug-in.

 

3. Reverse above procedure to reinstall.

 

ADJUSTMENT OF MOWER DECK DRIVE BELT

 

1. This mower deck drive  belt is tensioned by a spring loaded engagement idler 

quadrant.

 

2. This system is designed to  m a i n t a i n the proper belt tension at all times.

 

3. Belt t e n s i o n can be adjusted by m o v i n g the engaging rod (P/N 7013) i n t o the 

outside hole of engagement handle (P/N 7020).

 

4.  After   belt  tension   is adjusted, check to assure  that  the  mower  blade  w i l l  

not turn freely when the engaging rod is in the "OFF" positon.

 

5. If the mower blade turns freely, adjust the blade brake by  loosening nut (P/N 

3205) at the end of the brake rod (P/N 2988).

 

6. A f t e r adjustment is achieved, perform  the safety  checks l i s t e d  below.

 

Page 1 of 7