Roland FJ-50 用户手册
19
2 Basic Operation
2-4 Loading the Material
Roll material must be placed at a
predetermined shaft position.
predetermined shaft position.
Failure to do so may
result in falling of the
roll, leading to injury.
result in falling of the
roll, leading to injury.
Acceptable material widths
FJ-50
210 mm to 1350 mm (8-5/16" to 53-1/8")
FJ-40
210 mm to 1125 mm (8-5/16" to 44-1/4")
Secure the retainer on the left-hand side in place at the
location shown in the figure.
Tighten the screw to secure in place.
location shown in the figure.
Tighten the screw to secure in place.
* When using roll material, the retainer on the left-
hand side should always be used secured in
place at the location shown in the figure.
place at the location shown in the figure.
1
Loading Roll Material
Rear
Left-hand retainer
100 mm (3-15/16")
Line up with the core diameter of the loaded roll material and refit
the left- and right-hand media flanges.
the left- and right-hand media flanges.
2
Media flange
Flange retaining pin
(1)
(2)
Media flange
(3)
Line up the ridges and grooves.
(4)
76.2 mm
(3")
50.8 mm
(2")