Radio Shack 60-4358 用户手册

You will need...
One 9V Battery for the Transmitter
One 9V Battery for the Hummer H2
One 7.2V Rechargeable Battery Pack

• Turn off the Hummer H2.

• Remove the battery com-

partment cover.

• Place the 9V battery in the 

battery compartment, 
matching the polarity sym-
bols (+ and -) as marked 
inside.

• Place the battery pack in the 

recessed area with the bat-
tery pack’s connector on the 
same side as the Hummer H2’s matching connector.

• Attach the battery pack’s connector to the Hummer H2’s match-

ing connector. They fit together only one way. Do not force them.

• Close the cover.

Install Battery in the Transmitter
• Turn the transmitter off.
• Slide the battery compartment 

cover in the direction of the arrow 
to open it.

• Place the 9V battery in the com-

partment, matching the polarity 
symbols (+ and -) as marked 
inside.

• Replace the cover and snap it 

shut.

• Route the antenna wire’s loose end through the supplied antenna tube.

• Insert the antenna tube securely into the Hummer H2’s antenna tube hole at the top of 

the vehicle.

• Extend the transmitter’s antenna to its full length for best reception.
• Turn on the transmitter and the Hummer H2. The headlights and the LED indica-

tor illuminate.

• Select the specific fre-

quency by setting the  
Band ABC switch on the 
transmitter and the Hum-
mer H2 to the same 
band.

• Use the transmitter’s 

speed control trigger to 
move forward and 
reverse. Pull the trigger 
toward the handle to 
move forward. The head-
lights illuminate. Pull all 
the way back for maxi-
mum speed. Push the trig-
ger away from the handle to 
move backward. The tail-
lights illuminate. Release to 
stop. 

• Use the transmitter’s steer-

ing wheel control to turn the 
Hummer H2 left and right.  
Release the steering wheel 
to drive straight.

• Turn the transmitter and the 

vehicle off when you finish 
playing with it.

Trim I
The transmitter’s neutral trim control lets you fine-tune the speed 
control so the Hummer H2 stops completely when you release the 
speed control to its center position. If Trim I is set too far to the 
left, the vehicle will move backward. If it is set too far to the right, 
the vehicle may continue forward.

The transmitter’s steering trim control lets you fine-tune the steer-
ing so the Hummer H2 drives in a straight line. If it is set too far to 
the left or right, the vehicle may drive in those directions.

• Turn the Hummer H2 over on its side so the tires do not touch 

the ground.

• Turn on the transmitter and the Hummer H2.
• If the tires move, turn Trim I until the tires stop.
• If the front tires appear to angle left or right, adjust Trim II until 

the tires appear to be straight.

• When you finish your adjustments, turn off the transmitter and 

the Hummer H2.

Do not touch the tires or the steering control during this adjust-
ment. You may have to fine-tune the trim controls after using the 
Hummer H2 for a while.