Uniden d3580 用户手册

1.  Unpack all handsets, 

battery packs, and 

battery covers. If you 

need to remove a 

cover, press in on the 

notch and slide the cover down and 

off.

2.  Line up the battery connector with 

the jack inside the handset; the 

connector only fits one way. 

3.  Push the connector in until it clicks 

into place; tug gently on the wires 

to make sure the battery is securely 

connected.

4.  Replace the battery cover and slide it 

into place.

5.  Use an AC adapter to connect the 

power jack on the base to a regular 

indoor (120V AC) power outlet. 

Connect any chargers the same way. 

6.  Place a handset in the base with the 

display facing forward. If the display 

doesn’t light up, reseat the handset or 

connect the base to a different outlet. 

For 2 or more handsets, place each 

handset in a charger. 

#

Use the telephone cord to connect the 

 jack on the base to a standard 

telephone wall jack.
Test the Connection

1.  Pick up the handset and press 

. The handset sounds a dial 

tone, and the display shows 

. 

 

–

If you don't hear a dial tone or the 

display says 

check 

the connection between the base 

and the phone jack. 

2.  Make a quick test call. (Press 

 to 

hang up.) 

 

–

If you keep hearing a dial tone, 

change to pulse dialing.

 

–

If there’s a lot of noise, check for 

interference (see page 23). 

3.  Test all handsets the same way. If 

you can't get a dial tone, move the 

handset closer to the base. 

Your phone uses tone dialing by default. 

If your phone company uses pulse 

dialing, you need to change your phone’s 

dial mode.
1.  Press 

; choose 

.

2.  Select 

 then 

. You’ll 

hear a confirmation tone. 

To send DTMF tones during a call (e.g., 

for an automated response system), 

press 

 to temporarily switch to tone 

dialing. When you hang up, the phone 

automatically returns to pulse dialing.

Line up the holes on each side of the 

handset. Insert the belt clip into the 

holes on each side of the handset. Press 

down until it clicks.
To remove the belt clip, pull either side 

of the belt clip to release the tabs from 

the holes.

You can order a wall-mount bracket 

from the Uniden website. Follow the 

instructions that come with the bracket.