Kenwood KAC-6403 用户手册

English

Installation

2 CAUTION

• Do not install in the below locations;

(Unstable location, In a location that interferes with driving, In a location that gets wet, In a dusty location, In a
place that gets hot, In a place that gets direct sunlight, In a location that gets hit by hot air)

• Do not install the unit under the carpet. Otherwise heat build-up occurs and the unit may be damaged.
• Install this unit in a location which allows heat to easily dissipate.

Once installed, do not place any object on top of the unit.

• The surface temperature of the amplifier will become hot during use. Install the amplifier in a place where

people, resins, and other substances that are sensitive to heat will not come into contact with it.

• When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing

hazardous on the opposite side such as a gasoline tank, brake pipe, or wiring harness, and be careful not to
cause scratches or other damage.

• Do not install near the dashboard, rear tray, or air bag safety parts.
• The installation to the vehicle should securely fasten the unit to a place in which it will not obstruct driving. If

the unit comes off due to a shock and hits a person or safety part, it may cause injury or an accident.

• After installing the unit, check to make sure that electrical equipment such as the brake lamps, turn signal lamps

and windshield wipers operate normally.

Installation board, etc.
(thickness : 15 mm or more)

Self-tapping screw
(ø4 × 16 mm)

Ø4.6

230 mm

244 mm

330 mm

254 mm

204 mm

B64-3354-00_00_M_English.indd 3

05.11.17 10:21:20 AM