Konica Minolta kn-304 用户手册

Chapter 5  NetWare Setup

KN-304 Network Board 5-5

●

 Setup for Bindery Emulation

Make sure of the Bindery Context.

Before connecting the KN-304 print server to the Novell NetWare 4.x server of bindery mode,

make sure that the NetWare server contains the bindery context.

If the bindery context does not exist, the network administrator should modify the

AUTOEXEC.NCF file to add an adequate SET command and restart the NetWare server or

enter a SET command from the console prompt to make changes.

Note that any command entered following the console prompt is effective immediately but the

definition of the autoexec file becomes effective only after turning off power and on again.

Perform the following procedure to check if the contains the bindery context.

Log-in to the file server by the name of ADMIN.

Respond to the MS-DOS prompt with TYPE Z:\SYSTEM\AUTOEXEC.NCF.

When the file contents are displayed, see if a line exists that is something as follows.

SET BINDERY CONTEXT=0=<Name>

=0= denotes the file server context.  Use the actual file server context.

<Name> identifies the server context and can be found when PCONSOLE is activated as it is

indicated at top left in the Available Items menu window.

If no name is defined, the KN-304 does not work.  A name must be defined first of all.  For this

purpose, terminate PCONSOLE and add the following line in the AUTOEXEC file by using a

text editor.

SET BINDERY CONTEXT=0=KONICA_CORP

After adding the line, turn off power and restart the server.  Now the modification is effective.

Alternatively, the network administrator can enter a SET command from the console prompt

to make immediate modifications.  At this time, all modifications are lost once the server is

turned off and restarted.

Note that any command following the console prompt is effective immediately but the definition

of the autoexec file becomes effective only after the system is restarted after turning off power.