Fagor nc-200 pb 安装指导

A special mode has been created in order to make machine setup easier. This
mode is accessed from the main menu. Special care must be taken since software
and hardware limits are ignored in this mode.

Section 3.1, PAR21 through PAR24 describes the correspondence between the
display digit number and the number of the connector pin to be tested.

· Press 

· Use 

 to select TEST and press 

 .

This unit requests a password to access this mode: 719200

The message display offers four options that may be selected with 

  

· The 1st line shows 0's and 1's indicating the status of inputs I1 through I8

from right to left.

· The 2nd line shows the status of inputs I9 through I15.

Digital outputs

· The 1st line shows 0's and 1's indicating the status of outputs O1 through

O8 from right to left.

The outputs are activated or reset by pressing their relevant key.

  for O1 and 

 for O8.

· The 2nd line shows the status of outputs O9, O10 and O11; but they can

· The 

 key activates all the outputs.

· The 

 key resets all the outputs.