Compustar cm1000s r200 用户手册

 

 

Aux Button (1.5 Sec.) – Holding this button for 1.5 seconds will activate an auxiliary trigger on your 
vehicle. This is an optional function and could be used to unlock your trunk or open sliding doors. 

 

___________________________________________________________________________________________________________________

Valet Mode bypasses the functions of your remote starter. It is used in the event you bring your vehicle in for service, loan your vehicle to 
someone, or if you have your vehicle parked by valet service. Valet Mode is used as a precaution so there is no accidental activation of the 
remote start.  

To place your system into Valet Mode you must turn the Ignition On and Off for 5 times within 7 seconds with key. When the parking lights 
flash once, pauses and then flashes twice, your system is now in Valet Mode. Please follow this diagram below: 

 
 
 
 
 
 
 

 
 
 
 
___________________________________________________________________________________________________________________

 
       1. Whenever the system fails to remote start, the vehicle provides you with diagnostic error messages: # of times parking lights flash. The  
           vehicle will first flash the parking lights 3 times followed by the remote start error. 
 

Number of Parking 

Light Flashes 

Remote Start Error 

1 Motor 

running 

2 

Key in ignition on position 

3 

Door open (manual transmission only) 

4 Trunk 

open 

5 

Foot brake on 

6 Hood 

open 

7 

Reservation off (manual transmission only) 

8 

No tach signal or voltage sensing failure  
(please see your CompuStar installer) 

 

 

2. Depending on the vehicle, it may be possible that the factory remote may not operate while the vehicle is remote started. It is not an  

 

  error the CompuStar. It is a function of the vehicle disabling factory features while the car is running. 

 
___________________________________________________________________________________________________________________

 
To use the remote-start function on a manual transmission vehicle, you must first set Reservation Mode. Reservation mode sets the vehicle up 
to safely start the next time you use the remote-start. To set Reservation Mode, follow these steps: 
 

1. 

Completely stop the vehicle and put it in NEUTRAL. 

2. 

Set the emergency brake and remove your foot from the foot brake. 

3. 

A few seconds later you should hear a “click”. 

4. 

Turn the key off and remove it from the ignition. The vehicle will stay running. 

5. 

Exit the vehicle and close the door. 

6. 

The vehicle will shut off, the system will arm, and the doors will lock. 

 
Reservation Mode has now been set. The following actions will cancel Reservation Mode; opening the hood, doors, or trunk, turning on the 
ignition, releasing the emergency brake, turning on the ignition, or triggering the alarm. If reservation mode is cancelled, you will need to get in 
the vehicle and repeat the setup process.