Konica Minolta 7013 psc 用户手册

NetWare Configuration-7

Novell's NetWare 4.0x can operate in two modes NetWare Directory Services (NDS) 
and Bindery Services Emulation. For NDS, see 4.3 Configuring the Print Server Card 
in NetWare Directory Services. These services run simultaneously and transparently to 
each other. The Print Server Card may be configured to operate with Bindery Services 
mode only (this section), or to operate under NDS (4.3 Configuring the Print Server 
Card in NetWare Directory Services). When configured under NDS, the print Server 
Card will also service older file servers operating in bindery mode.

Note:   If the Print Server Card is not properly set up for NDS and the Bindery Services

mode is not running, the Print Server Card can not find its file servers, and the sta-

tus page indicates the Novell NetWare protocol is not active.

Before installing the Print Server Card on a Novell NetWare 4.x server in Bindery 
Emulation mode, check that the server has a Bindery Context (name for the server 
under Bindery Services mode). If the server does not have Bindery Context, it may be 
preferable to install in NDS mode. If the Print Server Card must be installed in the 
Bindery Emulation mode, the server must have Bindery Context.  Perform the follow-
ing steps to confirm the server has Bindery Context:

1. Go to the 4.x server and at the system console type: load install

2. Select Maintenance/Selective Install from the menu.

3. Select NCF Files Options from the menu.

4. Select Edit AUTOEXEC.NCF from the menu.

5. Search the file to see if you have a statement similar to the following included:

 SET BINDERY CONTEXT=0U=ENG

Where =0U=ENG is an example of a name for the file server context. Use your

own file server context in place of =0U=ENG.

6. At the console prompt, type the SET BINDERY CONTEXT statement that you 

entered in the AUTOEXEC.NCF file.