Konica Minolta 7013 psc 用户手册
TCP/IP Configuration-4
5. Enter the IP address that you want to assign to the Print Server Card, its Subnet
Mask (make sure it matches what you are using on your subnet), the Default Gate-
way (your router's IP address), and the MAC address of the Print Server Card
(Hardware Address, listed on the Status sheet as Ethernet Address). Use colons as
delimiters as shown on the status sheet rather than the dashes that Windows uses.
6. Click on Go. You will get a message that the program is Verifying, and then it will
tell you whether the unit is active or not.
7. Wait for about five minutes for the Print Server Card to reset. The Status sheet
should report the newly entered IP information.
8. Enter the MS/DOS box. At the command prompt enter:
ping [IP address of Print Server Card] (continue
until you get a reply)
If it does not respond, verify that TCP/IP is enabled on the status sheet. If the status
sheet does not show the IP information, then repeat the above procedures.
sheet does not show the IP information, then repeat the above procedures.
7.1.1.6 Setting up IP and
lpr
Parameters
The Print Server Card provides for a setup connection via the standard Telnet port. To
be able to make changes to a unit with factory default settings, you must logon as
"sysadm". The default password is also "sysadm" (This password can be changed
from the Telnet utility). Section 7.5 Running Telnet, describes the use of the Telnet util-
ity.
be able to make changes to a unit with factory default settings, you must logon as
"sysadm". The default password is also "sysadm" (This password can be changed
from the Telnet utility). Section 7.5 Running Telnet, describes the use of the Telnet util-
ity.
1. Telnet to the Print Server Card (the login and password are both "sysadm").
2. Turn off the protocols that you are not utilizing (option 3).
3. Setup the subnet mask and default gateway for the Print Server Card if applicable
(menu option 1). (If you used BOOTP, this will already have been done).
4. Exit, Save and Reset the Print Server Card.
You can also use the HTML pages accessible via MAP or a Web Browser to setup lpr.
The password to change parameters with the HTML pages is the same as the Telnet
password.
The password to change parameters with the HTML pages is the same as the Telnet
password.
7.1.1.7 Creating an
lpr
Queue on the Workstation
Once you install the spooler onto the workstation, the setup program will create a
group and icon.
group and icon.
1. Double click on the spooler icon.
2. Click on setup, and define a new queue.